C-11 – Combination Can Punch and Countersink
The C-11 Combination Can Punch and Countersink is used to punch a hole and provide a flattened surface to allow for installation of the C-5 and C-9 thermocouple receptacles. The C-11 is a two piece draw-through construction that requires a pilot hole to be made with an awl (C-15) and it can be used on any part of the container or lid.
C-12 – Lever Type Can Punch
The C-12 Lever Can Punch can be used only on the side of a can or to punch a hole in a lid of a can or jar before sealing the lid to a the container. It does not require a pilot hole. If you anticipate numerous tests and are inserting the thermocouple in the side of the can, the C-12 offers speed and convenience.
C-12-EM – End Mount Lever Type Can Punch
The C-12-EM End Mount Lever Can Punch is used to punch a hole in the deep bottom of a can for end mounting. Included is a centering disk for different can sizes; it does not require a pilot hole.
Punch
3/8″ punch for use with C-5.1 and C-5.2
(Not for use with C-5.1M or C-5.1ML)
C-13 – End Wrench
The C-13 End Wrench has a 3/4” end for tightening the C-5 and C-9 thermocouple receptacles.
Note: A separate end wrench is available upon request with a 7/16” end for tightening the C-5.2 stuffing box and the C-8 packing nut.
C-14 – Spanner Wrench
The C-14 Thermocouple Spanner Wrench was designed specifically to tighten the thermocouple in the receptacle. Proper sealing of the thermocouple is achieved by finger tightening.
A wrench should never be used on the spanner wrench.
C-14-S – Spanner Wrench with Handle
The C-14-S Thermocouple Spanner Wrench with Handle was designed specifically to tighten the thermocouple in the receptacle and provides an easy to use screwdriver handle.
C-15 – Awl
The C-15 Awl is used to make a pilot hole for the C-11 Combination Can Punch and Countersink. The Awl has a shaft diameter of 1/4” (6.4 mm).